Security Labs SL800 Manual de Instalação descarregar pdf (Página 15)

SINGLE GATE OPERATOR INSTALLATION

OVERVIEW OF OPERATOR INSTALLATION

GATE PREPARATION

Level

Plumb

Concrete

Be sure the gate is properly installed and slides smoothly before installing the GTO/PRO Slide Gate Operator. The

gate must be plumb, level, and move freely. The gate must not bind or drag on the ground. Never use a wheel

on the gate, because the additional drag and resistance can cause the operator to obstruct.

The diagram below shows a single slide gate installation with recommended safety features. The operator must be

installed on the inside of the gate. GTO requires using safety edges and roller guards to help reduce the possibility

of bodily injury.

Chain

Safety Edge

Roller Guard

Receiver

(cable in separate

conduit)

Roller Guard

Safety Edge

CAUTION

AUTOMATIC GATE

STAND CLEAR

1-800-543-GATE

®

Operator

PRO-SL-2000

(REQUIRED)

Safety Edge

(REQUIRED)

Use PVC Conduit 

(not included)

Run 1000' (max.) of low

voltage wire to control

box from transformer

(wire not included).

120 Volt Indoor

Transformer

(Surge Protector

not supplied)

Roller Guard

(RE QUI RED )

Chain Bracket

for power cables.



1. KEEP CLEAR! Gate may move at any time.

2. Do not allow children to operate gate or

play in gate area.

3. This gate is for vehicles only. Pedestrians

must use a separate entrance.

Moving Gate Can Cause

Injury Or Death

WARNING

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 44 45

Comentários a estes Manuais

Sem comentários

Security Labs SL800 Manual de Instalação Página 15

Comentários a estes Manuais